Note: This page is the HTML version of the application guide. Please follow the dry/wet method instructions and drying times.
Preparation
Tools
- Felt squeegee
- Glass/surface cleaner
- Clean cloth
- Positioning tape (masking)
- Scissors/cutter
- Heat gun or hair dryer
- Spray bottle (water + 3 drops of dish soap/L)
- Optional: second person
Before you start
- Thoroughly clean the surface (dust/grease-free).
- Ideal working temperature ~20 °C; do not work with cold materials/parts.
- Depending on the bike: remove tank fairing/trim to wrap edges cleanly.
- Dry-fit: tape corners to check positioning.
⚠️
For wet application use only ~3 drops of dish soap per liter — more can reduce adhesion.
Dry application
- Clean the surface (dust/grease-free).
- Position decal with backing + transfer tape, fix at corners. Ensure correct orientation.
- Fold back half, peel some backing, cut off the peeled backing.
- Hold lifted half (second person if needed) and squeegee from center outward. Repeat for the other side.
- Remove transfer tape carefully; ensure the decal stays in place. Push remaining bubbles outward.
Wet application
- Clean the surface (dust/grease-free).
- Peel backing, lightly mist adhesive and surface (water + few drops soap/L).
- Place decal and slide into position.
- From center outward, push out liquid with light even pressure. Repeat until bubbles are gone.
- Carefully remove transfer tape and check again for bubbles/water.
Drying times & care
Dry method: ~18 h
Wet method: ~30 h
+12–18 h in cold conditions
????
Do not use car wash/hand wash during curing. Afterwards, wash normally — avoid pointing pressure washer directly at edges.
✅
boboom recommendation: wait at least 72 h before heavy cleaning or stress.
FAQs
Why light heating?
Gentle heating (heat gun/hair dryer) helps conform over curves. Do not overheat.
Small bubble left?
Tiny bubbles may disappear in 24–48 h. Alternatively, pin-prick and squeegee to an edge.